How To Setup A Transparent Content Filtering Proxy Aug 10, 2011 To speed up web access and block obscene content on my home network, I setup a transparent content filtering proxy on my Arch Linux server with the help of and. Below are the steps I took to get it all working. Install and configure Squid (web proxy) Squid will act as our proxy server which should speed up our web browsing and allow the content filter (DansGuardian, explained below) to function as it requires one. • Run: pacman -S squid to install • The default config file for squid is pretty much ready to go. It’s a good thing because there are an overwhelming number of configuration options.

Anyway, keep the default config but add/change the following in your **/etc/squid/squid.conf **file. Acl localhost src 127.0.0.1/32 http_access allow localhost http_access deny all http_port 3128 transparent dns_nameservers 208.67.222.123, 208.67.220.123 #OpenDNS FamilyShield DNS Note: The IP addresses specified for dns_nameservers are the DNS servers. This speeds up DNS lookups and provides a simple way to have an up-to-date blacklist for pornographic sites. This will work in tandem with DansGuardian to filter web content. • Start Squid by running /etc/rc.d/squid start Install and configure DansGuardian (content filter) DansGuardian is the powerful, fast, open-source content filtering engine we will use. Download Video Mp4 Lagu Goyang Dumang. Dell Optiplex 745 Drivers Free Download Windows 7.

It is very configurable but I will keep it simple for demonstration purposes. • Run: pacman -S dansguardian to install • Make sure the following configuration options are set in your /etc/dansguardian/dansguardian.conf file filterport = 8888 proxyport = 3128 • Start DansGuardian by running /etc/rc.d/dansguradian start Configure Your Router To make our solution truly *transparent *and avoid the need to configure each computer in our network individually, we need to make our router redirect outgoing web traffic to our proxy server that is running DansGuardian and Squid. Autotune Effekt Program Ma Tv. To do this, you’ll need a router running Linux (most do) and one that allows telnet or SSH access. I have a Netgear router and after searching on the web found that if you navigate to the address: setup.cgi?todo=debug (192.168.1.1 being your router IP, of course), the router will allow telnet access on port 23, with the same credentials you use to login to the web interface. Once you have connected, run the following command to redirect outgoing port 80 request: iptables -t nat -A PREROUTING -i br0 -s!